Energy Saving with KRELUS IR-Heaters

For more than 35 years KRELUS has specialised in the supply of custom-made infrared heating solutions. We are the most competent partner for custom-made IR-heaters for:

  • Converting of paper, films and foils
  • Textile, film, paper and foil coating
  • Thermoforming
  • Embossing
  • Laminating machine
  • Pre-drying and heating equipment

The superior KRELUS technology applies direct radiation from the heat source to the product. The special heater construction effectively blocks the heat loss to the reverse side. The fast medium-wave KRELUS-IR-heater allows operations with precise temperature control on product surfaces. Due to the very rapid reaction time of these IR-heaters, they can be switched off even for short breaks. With the optimised emission of the heat energy in the real medium wave range (+/- 3 microns) – where almost all products have best absorption – the KRELUS-IR-heater is more efficient and superior in comparison to traditional infrared heaters and allows energy and cost savings.

We are now able to supply the sizes 248mm x 248mm, 123mm x 496mm, 123mm x 248mm and
78mm x 396mm. These four new modules allow individually controlled radiation zones to be easily constructed to any desired size. These new KRELUS-IR heaters are of course particularly suited for use in thermoforming equipment and on continuous running lines to give accurate and consistent temperature profiles.

We shall be pleased to welcome you at our booth at ICE 2011: hall B6, stand 664.

More About This Company